SPECIFICATIONS OF FC
The F4 FC board is the same one on Beta75X drone. Click here for more detail information about the FC board.
- CPU: STM32F405 (Overclock to 240MHz)
- Six-Axis: MPU6000
- Size: 26mm x 26mm, whoop mounting pattern
- Firmware version: Betaflight OMNIBUSF4SD (OBSD)
- OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)
- TX02、RX02 ports is available, so that it could support TBS micro receiver
- RSSI ports is available
- Buzzer solder pads
- Support programable LED like WS2812 etc
- Weight: 2.7g
HOW TO ASSEMBLE FC & ESC
Note: Please assemble the FC and the ESC as the picture shown below, otherwise the fc will be BURNT to damage.
RECOMMENDED PARTS LIST
RECOMMENDED RECEIVER CONNECTION
All the ports are available on this board. So that you could connect any receiver you want on the board. For example.
- Frsky XM/XM+ Receiver
- TBS receiver
- DSMX receiver
For the details about how to connect the receiver and configure in Betaflight, please check the F4 2S Brushless FC & ESC Manual.
- 1 * F4 2S brushless flight controller