MPA is a Multi-Port Safe Parallel Module for safely interconnecting same-cell-count LiPo batteries in parallel; also supports RX/TX NiCds. This version supports LiPo batteries with JST XH compatible balance connectors and wiring. The MPA board has Deans Ultra male connectors on the board for the main power leads on your battery packs. If you do not use Deans on the power leads, we offer a Deans to bare wire adapter that permits the user to install the power connector of choice on the bare wires. Interconnect cables available separately to support Cellpro PowerLab 6/PowerLab 8, Cellpro 10XP, and other charger brands compatible with JST XH balance connectors and wiring.
Includes: support for safe parallel charging of up to 6 same-cell-count packs at one time (2s-8s); supports 40A max charge/discharge rate; every port reverse polarity fuse protection of main battery wires; every cell/balance wire protected by self-resetting polyfuses with temperature warning indicators; supports non-balanced charge of up to two 1s LiPos used with "indoor models"; supports 1 RX and 1 TX NiCd/NiMH battery pack. Works with any Cellpro charger or battery workstation equipped with "XH MODE WIRING" option. Interconnect cables available separately to support Cellpro PowerLab 6/PowerLab 8, Cellpro 10XP, as well as other brand chargers which are compatible with XH balance plugs and wiring. Be sure to purchase the proper cable to plug the MPA into your Charger or Battery Workstation.