Finally a solution from FrSky for all those micro brushed quads. F3EVO running betaflight and fully firmware upgradeable. Pre-soldered connectors makes this unit ready to install and bind. Upgrading your Tiny Whoop has never been easier.
Dimension: 29×29×6mm (L × W × H)
Hardware: STM32F303 CPU (72MHz inc FPU), MPU9250 (accelerometer/gyro/compass), CC2510 CPU for XM receiver
Channels: 16CH (8CH is RSSI) by SBUS to UART2 Rx of F3EVO
Operating voltage/current: 4.2V@75mA
Compatibility: FrSky Taranis X9D/X9E/Q X7/ Horus X12S/XJT in D16 mode
Built-in F3EVO and XM receiver module
(Notice: XM receiver is a one-way receiver (no telemetry), it will receive the commands of Remote Control and send to F3EVO by SBUS (8CH is RSSI) to UART2 Rx of F3EVO)
Features the latest Accelerometer, Gyro and Compass and Baro sensor technology.
The F3EVO runs the open-source Cleanflight/Betaflight flight control (FC) software and firmware upgradeable (SPRACINGF3EVO), the factory firmware is betaflight_3.0.0_SPRACINGF3EVO.
The XM receiver runs the software which was developed by FrSky and firmware upgradeable.